Jump to content

dutydruid

Registered Users

Change your profile picture
  • Posts

    4
  • Joined

  • Last visited

Reputation

1 Neutral
  1. hi dude the belts were the first thing on my check list and are plenty tight enough, the problem is very temperamental. ie it ha run for 5 days without a splutter then laqst night went to start it to get my wife and nothing , on first attempt, second attempt drew a bit of attention as it sounded like a gear change without use of the clutch and on the third try spot on again. i the ran it for the raest of the night shopping so plenty engine off engine on and it was fine. so the ghost continues to haunt me , and i say me cos it aint happened to my better half. the noise from the bearing is only audible in the cab when i hold the car using the clutch or half have it depressed just as we sit at lights etc. but i will check them again thanks party on dude
  2. hi yall over the past few weeks our(loosly put , the wifes )car has had a few odd things happen. No.1 cam position sensor went belly up sorted that one easy peasy, No.2 when the nice man from the fourth emegency service told me the original fault with the cps , he started the car and noticed a weird squeeling noised ( his response was ooh did you hear that) sincve then the noise has gotten progressivley worse. along with a grating noise on starting occasionaly does any on e out there know if this is a starter motor problem or the gear tooth on the fly wheel. PLESAE HELP ps thrust bearing on clutch is on its way out but just waiting for that one to die. party on dudes
  3. watcha dude just had a similar problem with my 03 mondeo turned out to be the CAMSHAFT POSITION SENSOR . fitted a new one problem solved. now the cost are you sitting down £ 14.05 inc vat from dealer party on dudes
  4. hi yall just signed up to to see if i can do any good with the bits of bad luck and good come to that matter. passing where relevant the correct (hopefully ) information. have a nice day and party on dudes8-)
×
×
  • Create New...